Rosendahl mif 4 Manuel d'instructions

- 1 - Instruction Manual mif 4 Rosendahl mif 4 is a professional midi timecode interface with LED display, sync input and USB port ww

- 10 - In GENERATOR mode the following video syncs are accepted as reference, depending on the selected timecode standard: 24 FPS: 1080p23

- 11 - 7. Setup utility The firmware version installed in your mif 4 is displayed for two seconds every time the unit is powering up.

- 12 - 8. USB drivers mif4 is a so called "device class compliant USB Audio Device" and does not need a driver installation. Windows XP

- 13 - 9. Declaration of conformity Rosendahl Studiotechnik GmbH Andechser Str. 5 D-86919 Utting a.A. Germany herewith confirms that the prod

- 14 - 10. Specifications LTC input: XLR 3-pin female, balanced, pin 1 = GND, 2 = (+), 3 = (-), 10 kΏ, reads forward, reverse and stationary time

- 2 -

- 3 - Contents 1. Unpacking and mounting into a 19" rack page 3 2. Powering up and selecting timecode SOURCE page 4 3. LTC

- 4 - 2. Powering up and selecting timecode SOURCE Connect the USB port to a host computer or use the external power adapter to supply your mif 4.

- 5 - 3. LTC input mode LTC is longitudinal timecode according SMPTE 12M, there are 80 bits containing time, userdata and a syncword. T

- 6 - Timecode faster or slower than 6% or timecode running reverse is translated into so-called MTC full messages. MTC full messages are use

- 7 - If the unit is in sync and outputs locked timecode, this LOCKED indicator will light up. In MTC or USB input modes the LOC

- 8 - Applied pull down video syncs (i.e. NTSC = 480i59.97) will change 30 FPS timecode frame rate automatically into pull down 29.97 FPS timecode fr

- 9 - 6. DISPLAY modes Press the right key to select one of four display modes: TC timecode in hours, minutes, seconds and frames. UB so-calle